Multi-purpose base - can be used independently to secure cables and wires, but can also be equipped with a Saddle Clip to support hoses. • Two alternative mounting methods for the base part - adhesive sticker or screws (or both) - No need for additional fasteners. It is possible to replace the Saddle Clip clip with a clip of a different size without removing the heel part (for example when changing the piping).<br />• Dovetail grooves in the lower part of the heel - better adhesion to different surfaces, no need for fastening parts.<br />• Heel made of UV-protected composite material (glass fiber reinforced Nylon 6 (PA6)).<br /><br />TruDesign Saddle Clips &amp; the holders are designed to enable neat and elegant routing of cables, wires and pipes and hoses. The base can be attached by screwing or gluing to the wall or bulkhead. The base can be used independently with a cable tie or it can be fitted with Saddle Clips, which are available in four different sizes (for pipes and hoses). <br /><br />If it is necessary to secure it, it can be done by threading a cable tie under the heel and further around the Saddle Clips clip and the hose/tube, so that all components can be locked together. If later there is a need to change the lines of the tubes, it can be done simply by removing the hose/tube from the Saddle Clip clip and pressing the arms of the clip against each other, causing it to detach from the socket. After this, it is possible to install a clip of another size on the base, if you want to change the hose/pipe diameter. The stem is available in one size option, to which it is possible to attach four Saddle Clips of different sizes.