Easy to use and highly effective paint remover. The liquid product penetrates even into very hard to reach places, holes and crevices. Removes old paints and varnishes effectively but gently from a wide range of surfaces, including wood, metal, stone, etc.

• Strong formula and fast action
• Do not open the cap near the face
• Removes most paints and varnishes
• Neutral colour for sensitive wood surfaces
• For wood, metal and stone surfaces
• 750 ml is sufficient for up to 2 m2 (approx. 1 door side)
• Flowing consistency for multi-purpose surfaces
• Fast-acting dichloromethane-free formulation
• Solvent resistant
• Application thickness 2-3 mm

Instructions for use:

Preparation:
Turn off all ignition sources close by (fires, boilers, stoves, indicator lights, etc.) DO NOT DARKEN.
Use appropriate protective gloves and goggles.
Always work outdoors whenever possible. Otherwise, ensure good ventilation by opening windows and doors. A ventilator can be used to promote air circulation. Do not use in confined spaces, e.g. basements, wells, etc. Without adequate ventilation, highly flammable and potentially explosive vapour concentrations can form.
Protect non-treatable parts and surrounding areas with protective plastic.
Not suitable for paint removal from plastics and fibreglass materials.
Do not use in direct sunlight.
Store in a dry and cool place, do not allow to rust.
Particularly effective for removing ABS, styrene polymers, rubbers and adhesive elastomers, not suitable for removing paints applied to these surfaces. For plastics of unknown composition, check compatibility with a small inconspicuous area.

Use
Pour into a suitable container and immediately close the screw cap. Apply a generous coat by patting. Do not brush off. Treat only 0,5 m2 at a time.
After the paint has blistered (5-10 min), apply a second coat over the blistered paint. Leave for up to 40 minutes. Reapply if the surface has dried.
Remove the blistered and softened paint with a paint scraper. Use an old nylon toothbrush in difficult areas. Repeat if necessary. Use a steel wool dipped in Nitromors to remove traces of stuck paint. Wash off with lacquer benzene and a metal file only. Allow to dry thoroughly and sand the surface with fine sandpaper or a metal file before applying new paint or varnish.

Cleaning
Warning: highly flammable.
Collect waste with old newspaper, leave waste outside in a safe place until dry. Dispose of in a trash can. Clean tools, etc. in warm soapy water and avoid contact with plastic sinks or baths.
Important: Surfaces may have been previously painted with lead-based paint (used before 1960). Special care must be taken when removing lead-based paints. Do not sand!
Very high VOC content above 50%. VOCs (volatile organic compounds) contribute to air pollution.