Eos 100H ventilation unit LTO Easily retrofittable ventilation unit with heat recovery to enhance gravity ventilation locally. One Pax Eos 100H device handles the ventilation of one floor (about 70-80 m2). The Pax Eos 100H is equipped with an intake air preheater. Also available is Pax Eos 100H+, which comes with a plug cord (LVI 7937312).
Eos is perfectly suited to Finnish houses of the 50s and 60s because of their floor plans. The efficiency of the Pax Eos heat recovery device intended for Nordic conditions is almost 80%. Eos is fully automatic, the necessary adjustments are made with the remote control. Exhaust air is taken in through the grille on the side of the Eos device and taken out through the recovery cell. Ducting is therefore not needed for the outgoing air. There is no need to insulate the duct for fresh air coming from outside if the device is located next to an external wall. Can be installed either on the ceiling or on the wall. The ducts of the incoming air heated by the recovery cell run indoors to other rooms, so they don't need insulation either. The risk of air leakage is also non-existent, because the room openings are in the inner walls. Pax Eos is therefore really easy and quick to install, also because it takes place indoors. Duct runs are often short, so Eos is also suitable for houses with low room height and houses where ducts cannot be installed in the upper floor. The Pax Eos 100H device has an inlet air preheater to ensure that the temperature of the incoming air is pleasant. Pax Eos has a compact size. Its length without pipe connections is only 595 mm, height 340 mm and depth 191 mm. The device weighs 9.5 kg. Pax Eos captures the house's own heat and reuses it. The exhaust air blown out through the Pax Eos uses a cross-flow cell to heat the incoming fresh outside air without mixing it, so that most of the incoming air is already heated. It is economical and significantly increases living comfort. The Lto efficiency is up to 80 percent.
Pax Eos is automatic, so its settings do not need to be adjusted often. The necessary adjustments to the device are easily made with the supplied remote control. The ventilation power can be adjusted to three different strengths: 30, 52 or 78 cubic meters per hour. The rule of thumb is that the air inside the home should be changed every two hours. Pax Eos is an intelligent and versatile ventilation device. It has a humidity sensor that automatically boosts ventilation during, for example, a shower or a bath. When the shower room is dry again, the ventilation power returns to the preset level. Ventilation capacity 78 m3/h, sound level min-max 18-35 dB(A) 3m, consumption 3.5-25 W (preheater max 375 W), enclosure class IP24, LTO efficiency 75-80%.