PP product solar panel end bracket to the wall

End brackets are installed on the first and last panel of the row of panels to keep them in place throughout the installation.

Installation instructions :

Prepare the mounting rail:

Make sure that the mounting rails are firmly installed on the ceiling or other mounting base at the right angle and at a distance from each other.

Place the first panel in place:

Lift the solar panel onto the installation rail and place it in the desired position. Make sure the panel is straight and properly aligned with the rails.

Place the end bracket:

Place the end bracket over the edge of the panel so that it presses the edge of the panel against the rail. The end bracket comes on the outer edge of the panel, either above or below, depending on which side you start the installation on.

Attach the end bracket:

Attach the end bracket to the rail with a screw. Make sure the bracket is firmly in place, but be careful not to overtighten the screw to avoid damaging the panel.

Install other panels:

Continue installing the other panels in the same way, but fasten them first with intermediate brackets and install the end bracket only on the outer edge of the last panel.

End bracket for the last panel:

After the last panel is installed, place the end bracket on its free edge and fasten it in the same way as the first end bracket.

Final inspection:


Check that all panels are straight and the fasteners are properly tightened. Make sure all end fasteners are tight and hold the panels securely in place.

Correct installation of the end brackets ensures that the solar panel system stays in place and lasts a long time.