For the highest shear stresses and dynamic loads.
Expands machining tolerances, seals and protects parts from corrosion.
The parts are not removable
Fast curing
Fills the gaps completely

Dosing cap for Dos system:
Convenient use with one hand thanks to the patented dosing cap, the other hand always remains free.
The dosing cap can be infinitely adjusted. The dosage can be adjusted according to the intended use and so that consumption and costs remain as low as possible. No substance remains in the neck of the dosing cap.
Better cost effectiveness: drains almost completely Used for the installation of cylindrical parts, especially with clearances up to 0.20 mm and when maximum strength is required at ambient temperature in assemblies that do not need to be disassembled (shafts and gears).
Especially suitable for assemblies where the joints are subject to dynamic stress.
Can be used to secure gears, plates, rings, pulleys and rotor shaft assemblies in electric motors and gearboxes. The surface must be clean and grease-free. Make sure the entire gap is filled with STOP FIX
For sliding assemblies, apply STOP FIX around the axle and on the rim of the tire, gently rotating during assembly to distribute the agent correctly
In press assemblies, quickly and carefully apply STOP FIX completely to both surfaces
For shrink fit assemblies, apply a coat of STOP FIX to the shaft. The tire is heated so that it has sufficient clearance during installation.
Do not move the parts until the strength is sufficient for handling. Very strong spindle attachment.

• Product length/depth: 4cm
• Product width: 4cm
• Product height: 14.1cm

CLP

Warning word : Danger
Hazard statements : H315 Irritating to skin. H317 May cause an allergic skin reaction. H318 Causes serious eye damage. H335 May cause respiratory irritation. H412 Harmful to aquatic life, long-term adverse effects.